Troubleshooting common issues with solar bore pumps

Solar bore pumps: There are few new emerging that help you to pull water from deep underground with low cost, and all the way green like in an eco friendly pattern. That is a good thing as these pumps are solar charged and therefore, they run on the energy of sunlight. But all machines sometimes need help, and these pumps have it as well. Below we will give you some tips and useful tricks to repair common problems in solar bore pump, so that you have your system working perfectly again.   

How to Increase Low Water Output for Solar Bore Pumps?  

Low water output from the bore pumps is a common problem many encounter with solar pumps. If you add too much water to the cooler, it will cover up the nut and plug on either side of one or both pump attachments. This means that not enough water is getting in there for them to work properly. The first thing to do is test the borehole water level. Check the Water Levels — This will be the number one reason why your pump isn't working well. Now, if you see that the water level is low then you can take a few actions. You may need to collect water elsewhere, dig a much deeper borehole or call in an expert who knows how to remedy these problems. 

The next question to be answered is whether bore hole water level is okay, if yes check the size of pump according to your land. It questions at times because of its size whether it will be able to pump enough water that suits your requirement In such a scenario, you might decide to upgrade the pump so that it can suck more water and work even better. Aside from that, there are other explanations why a solar bore pump kits has been providing low water output. Another could be an airlock in the system or a restrictive filter. Usually, these kinds of issues will need you to call a trained technician in order for them to be fixed correctly. 

Solar Panels in Bore Pump Systems Troubleshooting Problems and Solutions

A bore pump system will not function without the solar panel. A fault with the solar panel will have a significant impact on the performance of your pump. Few of the common issues that can occur to the solar panel are shading by trees or buildings, wearing out of panels and mistakes in installing/upgrading them. Issues with the solar panel. A poor or damaged condition of a solar cell could lead to low power output — sometimes switching pump not working at all. 

Shading: Check if there is any shading in the area where your solar panels are located to fix issues with solar panel. Other times, is the shade from trees or buildings that directly hits on the solar panels and decreases their output power. Similarly, if shading is a problem for you then it may mean cutting back the branches of the trees that are overhanging and blocking sunlight or moving to place where the solar panels can get more light. 

Ageing can also interfere with how the solar panels operate, which is another problem. Inspect the panels at regular intervals for any evidence of damage or problems. Once you see some of the signs that your panels are ageing, it might be time to replace them or speak with a professional in your area who will be able to guide on if this is the best solution for you. 

Solar Bore Pumps Overheating Problems Fixes

Another common solar bore pump issue is when a solar submersible pump overheats. While this can happen, more often than not it is because of how bright the sun has been or there may be an error with your borehole system. Pumps must not overheat as this can cause a breakdown and costly repairs you would like to avoid. 

If you suspect that your solar borehole pumps is at risk of overheating, the best place to start would be by checking the pump in order to ensure that all parts are working as they should. If you do – they can block up the system and prevent water from flowing. Helps keep the pump cool to reduce heat buildup Make sure the bore pump switch is switched to operate in sunlight mode and not DC solar pumping or this will make the pumps overheat. 

How To Deal With Problems Of Solar Bore Systems — Pump Cutoff And Restart Errors

Solar bore pump sometimes may be cutoff or restart errors occur. This more or less means that the pump may stop functioning all of a sudden, or start when it should not. This can result in a low voltage at the pump, overloading of system or slight failures to borehole connections 

Troubleshooting these problems can be done by looking at the battery settings and performance of the solar panel. So much should be charging and voltage to the pump is correct. At any sign of faults or problems, it is of utmost necessity that you address them immediately OR call a technician. Also make sure that the pump is earthed up correctly and check the borehole connection to see if it might be damaged or clogged. A faulty connection between two wires or damaged wire sheathing is usually the culprit for electrical issues.  

How to avoid blockages and dams inside solar bore setups? 

Solar bore setups cause blockages and pump damage problems when pumps are used to draw water from wells or boreholes. Obstructions such as loose grit, sand or foreign objects can block and harm the pump reducing efficiency and life span. 

One way to prevent these blockages is by placing a filter between the bore pump and the inlet pipe. The filter in this would collect all the dirt dust and other foreign matter before it reaches to pump. Also, the screens and pipes are regularly inspected for functioning properly. By monitoring for irregularities, such as blockages or other causes of damage to the main lines that go into your home you will be able detect problems early before they are too late. 

Conclusion

In summary, while solar bore pumps by SAMKING are an excellent tool to gain access to water located beneath your land or property in a more efficient manner they can suffer problems as any machine. With the above guide, and an experienced hand to help you out with your queries of solar bore pump repairs You can easily proceed through most problems that plague a solar bore pump. That is why direct sunlight bore pumps can certainly create a powerful supply of water, presented they are appropriately looked after and effectively retained. Keep maintaining that pump though so it remains the good and healthy solar bore pumps for years to come.